Engine Modeling and Control: Modeling and Electronic Management of Internal Combustion Engines - Couverture rigide

Isermann, Rolf

Couverture rigide

ISBN 10 : 3642399339 ISBN 13 : 9783642399336

Editeur : Springer-Verlag Berlin and Heidelberg GmbH & Co. K, 2014

Synopsis

Increasing performance demands on combustion engines for reduced fuel consumption and emissions, as well maintenance of satisfactory driveability, require improved processes for control of combustion and exhaust. In addition to structural changes, research suggests these goals can be achieved by higher variability supported by better actuators and sensors. So modern engines incorporate more manipulation variables and sensors and a complex electronic controls. The design of the many control and also diagnostic functions requires model-based methods taking into account mechatronic engineering principles.

This book treats physically-based as well as experimentally-refined engine models for gasoline and diesel engines and uses them to exemplify the design of various advanced control systems. The procedures, from measurements through simulation to calibration on test benches, are systematically described and demonstrated. The treatment spans not only the stationary but also the dynamic behavior of engines. Several new control regimens are detailed, such as multivariable feedforward and feedback control based on nonlinear net models, combustion pressure and HCCI control. Many new results with signal and process model-based fault diagnosis are used to show how on-board fault diagnosis can be considerably improved.

The book is directed at advanced students working in control, electrical, mechanical and mechatronic engineering and will also be useful for practicing engineers in the field of engine and automotive engineering.

A propos du livre

À propos de l?auteur

Rolf Isermann studied Mechanical Engineering and obtained the Dr.-Ing. degree in 1965 from the University of Stuttgart, Germany. In 1972 he became Professor in Control Engineering at the University of Stuttgart. From 1977-2006 he was Professor for Control Systems and Process Automation at the Institute of Automatic Control of the Darmstadt University of Technology. Since 2006 he is Professor emeritus and is head of the Research Group for Control Systems and Process Automation in the same institution. R. Isermann received the Dr. h.c. (honoris causa) from L'Université Libre de Bruxelles and from the Polytechnic University in Bucharest. In 1996 he was awarded by the "VDE-Ehrenring", and in 2007 by "VDI-Ehrenmitglied". The MIT Technology Review Magazine awarded him in 2003 to the Top Ten of Emerging Technologies in Mechatronics. In 2010 he received the Rufus Oldenburger Medal from the Ameri can Society of Mechanical Engineers (ASME: highest scientific award for lifetime achievements).

Détails de l'édition

• Éditeur: Springer-Verlag Berlin and Heidelberg GmbH & Co. K
• Date d'édition: 2014
• Langue: anglais
• ISBN 10: 3642399339
• ISBN 13: 9783642399336
• Reliure: Relié
• Nombre de pages: 658
• Coordonnées du fabricant: ProductSafety@springernature.com; ProductSafety@springernature.com; ; Poststr. 9; Darmstadt; 64293; Allemagne