Articles liés à Chatter Control in Induction Heat Assisted End Milling:...

Chatter Control in Induction Heat Assisted End Milling: To Improve Machinability of Stainless Steel and Medium Carbon Steels - Couverture souple

Amin, A.K.M. Nurul; Mohamed Mahmoud, Abdelgadir

 
9783659436543: Chatter Control in Induction Heat Assisted End Milling: To Improve Machinability of Stainless Steel and Medium Carbon Steels
Couverture souple
ISBN 10 : 3659436542 ISBN 13 : 9783659436543
Editeur : LAP LAMBERT Academic Publishing, 2013

Synopsis

The conventional induction heating method, used for heat treatment of parts has been customized as a novel method for heat assisted machining of metallic materials. This method is very clean and of low cost compared to laser heating. The method is especially applicable in milling operations with high width of cut, which a single laser can not cover and there is a need of employing multiple lasers. Heating time is very short and only the skin of the work piece is heated and removed during machining. Cutting forces are low due to lower yield strength of the materials at elevated temperature, chatter is damped and surface roughness and tool wear are low. This innovative method if applied to the industry would lead to higher productivity and lower cost of machining.

Les informations fournies dans la section « Synopsis » peuvent faire référence à une autre édition de ce titre.

Présentation de l'éditeur

The conventional induction heating method, used for heat treatment of parts has been customized as a novel method for heat assisted machining of metallic materials. This method is very clean and of low cost compared to laser heating. The method is especially applicable in milling operations with high width of cut, which a single laser can not cover and there is a need of employing multiple lasers. Heating time is very short and only the skin of the work piece is heated and removed during machining. Cutting forces are low due to lower yield strength of the materials at elevated temperature, chatter is damped and surface roughness and tool wear are low. This innovative method if applied to the industry would lead to higher productivity and lower cost of machining.

Biographie de l'auteur

Prof. A.K.M. Nurul Amin started his teaching and research career at BUET, Bangladesh from 1983 and currently working at IIUM, Malaysia as a senior professor. He has completed a large number of research projects and supervised many PhD and Master students. He is the author of 8 books and editor of 5 books and authored over 300 technical articles.

Les informations fournies dans la section « A propos du livre » peuvent faire référence à une autre édition de ce titre.

Éditeur
LAP LAMBERT Academic Publishing
Date d'édition
2013
Langue
anglais
ISBN 10 
3659436542
ISBN 13 
9783659436543
Reliure
Broché
Nombre de pages
132
Coordonnées du fabricant
non disponible
Personne responsable
KreGa Onlinehandel GmbH
4950000000000
info@krega-onlinehandel.de

Birkenweg 31
Brakel
33034
Allemagne