Articles liés à Induction Heat Assisted End Milling of Inconel 718...

Induction Heat Assisted End Milling of Inconel 718 and Ti6Al4V Alloys: A comparative Assessment of Machinability in terms of Chatter, Surface Roughness and Tool Performance - Couverture souple

Amin, A.K.M. Nurul; Hossain, Mohammad Ishtiyaq

 
9783659439933: Induction Heat Assisted End Milling of Inconel 718 and Ti6Al4V Alloys: A comparative Assessment of Machinability in terms of Chatter, Surface Roughness and Tool Performance
Couverture souple
ISBN 10 : 3659439932 ISBN 13 : 9783659439933
Editeur : LAP LAMBERT Academic Publishing, 2013

Synopsis

Inconel 718 is the most widely used in the aerospace industries, especially for gas turbine hot section components. Titanium alloys, on the other hand, have very high strength-to-weight ratio making them very suitable for aircraft engines and airframe manufacture. They account for 30% of the total engine mass in commercial and 40% in military projects. However, both these strategic materials have poor machinability, as a result of which they have dominated the major research interests in metal cutting industries in the past decades. One of the techniques to improve machinability is the use an external heat source during machining. LAM applications offered significantly lower cutting force, higher metal removal rate and smoother surface finish, however, high costs of lasers slowed down its implementation. A new approach is heat assisted machining using inducting heating suitable for end milling operation. This book reports a comparative analysis of machinability of these two very strategic materials and their behavior to induction heat assisted machining in terms of tool wear, cutting forces, surface roughness and vibration/chatter.

Les informations fournies dans la section « Synopsis » peuvent faire référence à une autre édition de ce titre.

À propos de l'auteur

Prof. A.K.M. Nurul Amin is a Senior Professor at International Islamic University Malaysia. He has completed a large number research projects and supervised several PhD and a large number of Master students. He has authored of 9 books, edited another 5 books and published over 300 technical articles. He has 1 patent granted and 7 others applied.

Les informations fournies dans la section « A propos du livre » peuvent faire référence à une autre édition de ce titre.

Éditeur
LAP LAMBERT Academic Publishing
Date d'édition
2013
Langue
anglais
ISBN 10 
3659439932
ISBN 13 
9783659439933
Reliure
Broché
Nombre de pages
196
Coordonnées du fabricant
non disponible
Personne responsable
KreGa Onlinehandel GmbH
4950000000000
info@krega-onlinehandel.de

Birkenweg 31
Brakel
33034
Allemagne