An Introduction to Design of Concrete Slabs on Grade for Professional Engineers

Langue : anglais

Edité par Independently Published Jul 2026, 2026

9798188874315

Série : Livre 76 sur 76 - Structural Engineering

Vendeur : AHA-BUCH GmbH, Einbeck, AllemagneAHA-BUCH GmbH

Vendeur avec une évaluation de 5 étoiles

Vendeur AbeBooks depuis 14 août 2006

Livre broché

Etat: Neuf

EUR 60,72

EUR 35,00 expédition 
Expédition depuis Allemagne vers Etats-Unis

Quantité disponible : 2 disponibles

Ajouter au panier
Retours gratuits sous 30 jours

A propos de cet article

Neuware - There are several factors that have a considerable effect on determining the design thickness of a concrete slab-on-ground and can be divided into above and below slab-on-ground factors. The type, strength, and uniformity of the subgrade or subbase are the below slab-on-ground factors and are discussed. The type of loads, magnitude of loads, and frequency of moving loads travel are the above slab-on-ground factors and are addressed. The concrete mixture design and strength of the slab-on-ground is discussed. In this discussion, the key factor in the design of a slab-on-ground-its thickness, h. Three classical design methods and the finite element (FE) method are available to engineers for determining the slab-on-ground thickness. The classical design methods are: Corps of Engineers (COE), Portland Cement Association (PCA), and Wire Reinforcement Institute (WRI). They are based on continuous support to the slab-on-ground and uniform modulus of subgrade strength, k. The slab thickness calculation is insensitive to minor changes in k-values; therefore, it is not critical to obtain an accurate k-value. It is, however, directly related to the strength of concrete defined by the concrete flexural strength, fr, which is measured in accordance with ASTM C78. The COE and WRI methods use a value equal to 7.5, while PCA method uses a value equal to 9. For heavy loading, however, it is recommended to use the lower factor of 7.5 with a factor of safety equal to 2; refer to Section 3-10. The FE method, Section 5-12, unlike the classical methods, does allow for variable modulus of subgrade in the analysis. Slabs-on-ground are designed for the critical load or load combinations that generate the maximum stress and maintain surface cracking at an acceptable level. Typically, forklifts control the flexural design of slabs-on-ground, storage racks control punching shear and concrete bearing design, while distributed live loads control negative moment design in aisles between distributed loads, dowels at joints, and settlement of slabs-on-ground; refer to Figure 5-1 (Packard 1996). Accordingly, the SER will design the overall slab-on-ground thickness for the allowable moving load that controls flexural stresses. The SER will then check for punching shear of concentrated, line, and distributed loads at localized areas where constructed, applied, or both, verifies that excessive settlement does not occur below a stationary load, and ensures that cracks are not developed in aisles between distributed loads. The design procedure covers subgrade conditions, steel reinforcement, and various details such as jointing, dowels, and the inclusion of vapor retarder, if needed.…

N° de réf. du vendeur 9798188874315

Titre
An Introduction to Design of Concrete Slabs on Grade for Professional Engineers
Auteur
J. Paul Guyer
Éditeur
Independently Published Jul 2026
Année de publication
2026
État de l'article
Neu
Reliure
Taschenbuch
Langue
anglais
ISBN à 13 chiffres
9798188874315
Poids de l'article
256 grammes
Dimensions
279x216x5 mm
Série
Livre 76 sur 76: Structural Engineering

AHA-BUCH GmbH

Einbeck, Allemagne

Vendeur avec une évaluation de 5 étoiles

Vendeur AbeBooks depuis 14 août 2006

Frais d'expédition de Allemagne vers Etats-Unis

Article7 à 10 jours ouvrés5 à 7 jours ouvrés
Premier articleEUR 35,00EUR 45,00
Les délais de livraison sont fixés par les vendeurs et varient en fonction du transporteur et du lieu. Les commandes transitant par les douanes peuvent être retardées et les acheteurs sont responsables de tous les droits ou frais associés. Les vendeurs peuvent vous contacter au sujet de frais supplémentaires afin de couvrir toute augmentation des coûts d'expédition de vos articles.

Modes de paiement

  • Visa
  • Mastercard
  • American Express
  • Carte Bleue
  • Apple Pay
  • Google Pay
  • Chèque
  • Paypal
  • Virement bancaire

Description de la boutique

Das Unternehmen AHA-BUCH GmbH: Seit der Gründung von AHA-BUCH im Juli 2005 ist unser Hauptziel, zufriedenen Kunden so schnell und so preisgünstig wie möglich ihren Bücherwunsch zu erfüllen. Unsere Firma beschäftigt 16 Mitarbeiter, die nur ein Ziel kennen: den Kunden und seine Wünsche! Auf über 3700 m2 Fläche haben wir über 100.000 Bücher, Modernes Antiquariat und Spiele auf Lager.

Spécialité

Kinderbücher & Kinderhör Casetten, German Books, Software, Natur & Tiere, Ratgeber, Sachbücher, Englische Bücher, Medizin & Gesundheit, Universität & Studium

Profil professionnel du vendeur

AHA-BUCH GmbH

Garlebsen 48
Einbeck, Allemagne 37574